Look for a small rectangular or square-shaped receiver box. Remove the receiver box cover to look at the dip switch settings. You will see four sliding buttons. The button configuration must match the remote control's configuration.
How do you adjust the DIP switch on a Harbor Breeze?
https://www.youtube.com/watch?v=gNTz25-Vxa0
What is a fan DIP switch?
A ceiling fan that you can control remotely has a wireless receiver attached to it. The receiver controls the speed of the fan in response to a signal sent by the remote. ... Push the “Dip” switch up or down, as per the instructions that accompany the ceiling fan, to set it for a specific RF (radio-frequency) signal.Jul 21, 2017
What if I lost my fan remote?
It is possible to remove the old remote control circuitry from inside the fan motor housing and replace it with an aftermarket remote fan controller. They are typically sold for modernizing old-school fans that don't have a remote at all. Big box hardware stores sell them.
Is there an app to control my ceiling fan?
Fan Remote 4+ Turn your Bluetooth Device into a convenient remote control for your ceiling fan. The “Fan Remote” app when paired with Home Depot's Universal Bluetooth Remote can operate your fan by turning on/off, change speeds to high, medium, low, and control your light kit including dimming feature.Sep 30, 2015
How do you adjust a DIP switch?
How do I move or change a DIP switch? Most DIP switches are very small in size and can be adjusted with a finger or finger nail. However, if you cannot move a DIP switch on a circuit board, use a small tool, such as a small screwdriver or paperclip, to gently adjust the switch.Nov 13, 2018
Where are DIP switches on Harbor Breeze ceiling fan?
https://www.youtube.com/watch?v=TUNG04UOoy0
How do you adjust a DIP switch on a ceiling fan?
https://www.youtube.com/watch?v=hmQQjXEWuQw
How do you reset a Harbor Breeze fan with a dip switch?
To reset your Harbor Breeze ceiling fan remote you need to turn the power off then on and then push the 'reset' button or 'learn' button under the back cover of the remote. Make sure you hold the reset button down until the light comes on and the ceiling fan speed goes to medium.
How do I fix my remote control fan?
https://www.youtube.com/watch?v=jINijGS9jPQ
Do ceiling fan remote receivers go bad?
The remote receiver varies the voltage and current to change the fan motor speed. But ceiling fan remote control units can go bad too. Before you even think about tearing the fan apart to diagnose a problem, replace the batteries in the transmitter first.
How do you sync a remote to a ceiling fan?
Turn the power to your fan off for 5-10 seconds and then back on using the wall switch. Quickly press the 'PAIR' button on the back of the remote control. This step should be done within three minutes of restoring power to the fan. Your fan should turn on low speed indicating the pairing was successful.Jun 18, 2020