HANS was invented in early 1980's by two biomechanical experts, Jim Downing and Bob Hubard. They recognized that racers were receiving serious head and neck injuries in crashes.
Where is HANS made?
Simpson's Hybrid S model is currently the only Frontal Head Restraint proven effecti The HANS Pro Ultra Lite is SFI 38.1 and FIA approved and made in the USA. The Pro Ul
Why was the HANS device developed?
This device was co-developed by Dr. Robert Hubbard, a professor of engineering at Michigan State University, and his brother-in-law, former IMSA car driver Jim Downing. The HANS device is designed to reduce the chance of injury caused by unrestrained movement of the head during crashes.
What does HANS device stand for?
head and neck support
How is a HANS Device supposed to fit?
NASCAR made the HANS Device mandatory in 2001, followed by the NHRA and Formula 1 in 2003. Most sanctioning bodies accept any head and neck restraint that meets the SFI 38.1 standard.23 Jun 2016
Can you wear a HANS Device without a helmet?
Do I need a special helmet? No. HANS helmet anchors fit any competition approved racing helmet. Because the HANS Device is the only head & neck restraint that directs the loads thru the forehead area, you can use an open face helmet with the HANS Device too.
How long is a HANS Device good for?
5 years
Who makes HANS device?
Dr. Robert Hubbard, who made major advances in motorsports safety with the invention of the HANS device, died Tuesday.6 Feb 2019
Where is HANS device located?
Primarily made of carbon fiber reinforced polymer, the HANS device is shaped like a "U", with the back of the "U" set behind the nape of the neck and the two arms lying flat along the top of the chest over the pectoral muscles. The device, in general, is supported by the shoulders.
When was the HANS device created?
Jim Hubbard, developed the device in 1986 and began to sell them to racers in 1991, can't attend a race without a driver telling him, "You saved my life. "Jeff Gordon, a few years ago at the All-Star Race, thanked God and thanked HANS for saving his life in a crash," he said.4 Aug 2011
Are HANS Devices dated?
Tethers are dated. Replace every 5 years, after major impacts or sooner if wear is observed. Tethers should be replaced after any major impact. Examine your HANS Device visually and run your finger around the edges.
What is HANS type?
HANS is actually a trademarked name an acronym for Head and Neck Support that only certain manufacturers can use. It's the most common term for these devices. A Hybrid FHR uses a non-traditional design (shown later in the guide) with straps around the driver's torso.