What is Lockout/Tagout/Tryout? Lockout/Tagout/Tryout (LOTO) protects a worker by preventing others from turning on equipment or from a release of energy while working on or servicing equipment & machinery, working inside a grain bin, and working around conveyors and augers.
What is meant by lockout tagout?
The term “lockout tagout” refers specifically to procedures used to ensure that equipment is shut down and inoperable until maintenance or repair work is completed. They are used to keep employees safe from equipment or machinery that could injure or kill them if not managed correctly.18 sept 2019
What is a lockout/tagout and why is it important?
Lockout/tagout is a system that blocks all incoming energy, and discharges all stored energy in the equipment, making it physically impossible for it to run or move. Workers need to be trained over lockout/tagout procedures in their workplace to protect themselves from injury.
Who are the only ones that are authorized to hang or clear a lockout tagout?
Lockout or tagout shall be performed only by the authorized employees who are performing the servicing or maintenance. Notification of employees. Affected employees shall be notified by the employer or authorized employee of the application and removal of lockout devices or tagout devices.
Who is the only person that can perform a lockout/tagout on the machine?
1. Authorized employees. As a general rule, this group might include your electricians, maintenance personnel, and some machine operators. These workers are the only ones allowed by OSHA to perform LOTO.2 feb 2009
Who are the only employees allowed to participate in a lockout/tagout procedure?
147, the control of hazardous energy. Authorized (Qualified) Employees are the only ones certified to lock and tagout equipment or machinery.
Who Must an authorized employee notify before hanging or removing a lockout tagout?
Who must an Authorized Employee notify before hanging or removing a lockout/Tagout? According to 249-SPI-073, what must be developed and reviewed by a Supervisor before an Authorized Employee can remove any locks or tags and restore equipment.5 oct 2020
Can any lock be used for lockout?
Per OSHA, multiple-keyed or keyed-alike locks may not be used for the purpose of lockout/tagout. Any locks used must have only a single key, which must be under the exclusive control of the employee that applies the lock and is performing the service.26 feb 2021
What are the exceptions to the lock out/tag out requirements?
Note: Exception: The employer need not document the required procedure for a particular machine or equipment, when all of the following elements exist: (1) The machine or equipment has no potential for stored or residual energy or reaccumulation of stored energy after shut down which could endanger employees; (2) the ...
When should locks and tags be removed?
Lock-out & tag-out is necessary whenever you are working on and around any equipment and you could be injured by: > Unexpected start-up of the equipment > The release of stored energy. Two examples: - When you must remove or bypass a guard or other safety device.1 ene 2001
What must be done before removing lockout tagout?
- The machine or equipment must be cleared of tools and materials.
- Workers must be removed from the machine or equipment area.
- All lockout or tagout devices may then be removed.