SAE Flanges are made to SAE J518/ISO 6162 standards and are designed for hydraulic applications. SAE Flanges are also known as code 61 flanges or code 62 flanges. ... Because of the o-ringo-ringAn O-ring, also known as a packing or a toric joint, is a mechanical gasket in the shape of a torus; it is a loop of elastomer with a round cross-section, designed to be seated in a groove and compressed during assembly between two or more parts, forming a seal at the interface.https://en.wikipedia.org › wiki › O-ringO-ring - Wikipedia seal design, SAE flanges provide connections with reasonable assemble torque range. Material: SAE Flanges are made of ferrous material.
What is the difference between Code 61 and Code 62 flanges?
SAE Code 61 and Code 62 Code 61 is intended for for pressures up to 3,000 psi. Code 62 is intended for up to 6,000 psi. Bolt hole spacing and flange head diameters are larger for the higher pressure Code 62 fittings. The female port is an unthreaded hole with four bolt holes in a rectangular pattern around the port.
How thick is a Code 62 flange?
0.305 inches
What is a code 61?
Australia Country Code 61 Country Code AU.
How do you assemble a flange?
- Inspect components to ensure that male and female port threads and sealing surfaces are free of burrs, nicks and scratches, or any foreign material.
- Lubricate the O-ring.
- Position flange and clamp halves.
- Place lock washers on bolts and insert through clamp halves.
- Hand tighten bolts.
How do you install a pipe flange?
https://www.youtube.com/watch?v=ahEnJGO2ss0
How do you bolt a flange?
Tightening sequence The first pass, lightly tighten the first bolt then move directly across or 180 degrees for the second bolt, then move1/4 turn around the circle or 90 degrees for the third bolt and directly across for the fourth. Continue this sequence until all bolts are tightened.
How are flanges attached to pipes?
Socket-weld pipe flanges are typically used on smaller sizes of high pressure pipes. These flanges are attached by inserting the pipe into the socket end and applying fillet weld around the top. This allows for a smooth bore and better flow of the fluid or gas inside of the pipe.
What is SAE J518?
SAE J518 is commonly used world wide to connect larger sizes of hose and tubing (3/4” to 3”) in fluid power systems. SAE J518 is interchangeable with ISO 6141, DIN 20066 and JIS B 8363, except for the bolt sizes. ...
How can you tell the difference between Code 61 and Code 62 flanges?
Code 61 and Code 62 flange differs by a meager 0.064 in. for dimension A and only 0.188 in. ... However, the Cat version differs from the standard SAE Code 62 flange head in one aspect. The SAE Code 62 thickness (dimension C in the illustration) ranges from 0.305 in.Sep 11, 2015