What are hydraulic fittings? Hydraulic Fittings are used to connect a hydraulic hose to components like hydraulic cylinders, pipes, tubes, or different types of hydraulic hoses. The different types of hydraulic fittings allow the fluid to flow, change its direction, divert, or mix.
How do you identify hydraulic fittings?
- Identify whether they are male or female threaded fittings.
- Identify the thread as BSP, Metric or JIC flare etc.
- Identify the thread size. If in doubt then measure the OD (male) ID (female) of the thread and the pitch.
First you should determine the length of a hydraulic fitting by laying it on a table and then stretching your measuring tape across the top of it. Next, determine the outside diameter of the fitting by using your ID/OD calipers. ... The number you see on the top scale will be the correct reading for the outside diameter.Sep 25, 2020
How do you measure a hydraulic fitting?
- First you should determine the length of a hydraulic fitting by laying it on a table and then stretching your measuring tape across the top of it.
- Next, determine the outside diameter of the fitting by using your ID/OD calipers.
How do you determine your fitting size?
https://www.youtube.com/watch?v=ifPkWJuBJoM
What do the numbers on hydraulic fittings mean?
Simply put, a dash size refers to a diameter of a hose, tube or fitting in 1/16" increments. ... Each dash size corresponds to a progressively larger diameter, measured in sixteenths of an inch. “-1” is 1/16, “-2” is 2/16, and so on. In this case, -6 hose would indicate a hose with an inside diameter of 6/16”, or 3/8".
What are hydraulic fittings called?
The three most common types of hose fittings are O-ringO-ringAn O-ring, also known as a packing or a toric joint, is a mechanical gasket in the shape of a torus; it is a loop of elastomer with a round cross-section, designed to be seated in a groove and compressed during assembly between two or more parts, forming a seal at the interface.https://en.wikipedia.org › wiki › O-ringO-ring - Wikipedia, mated angle and threaded. However, there are several more types of hydraulic hose fittings available. O-Ring: The three types of O-ring seal designs are O-ring boss, flat face O-ring seal and O-ring flange.Aug 24, 2017