There are three things to do if your bathtub has toilet bubbles.

A bathtub should not be used for communication with the toilet.You need to fix your bathtub as soon as possible if you notice it bubbling orgurgling when you drain it.

It's a sign that the drainpipe or vent stack are not working if the toilet bubbles when you drain it.Negative air pressure inside the drainpipe/vent causes the toilet to fill with bubbles.

The bathroom drainpipes are joined together in the main house drainpipe.They share the same vent stack.The other fixture will be affected by a problem with one fixture.

A plumbing structure is like a tree.There is a tree with branches and a trunk.The tree trunk is represented by a single fixture which goes into the main house drainpipe.

If the main house drainpipe is not working you will have a problem.It is possible to notice that the toilet bubbles when flushed.

The space between the bathtub and the drainpipe will be full of air since a vacuum cannot exist.The air in the drainpipe will be displaced when you start draining the bathtub.

The air will escape through the bottom of the toilet bowl.When a bathtub is draining, toilets bubbles.

Sometimes the main house drainpipe is not the cause of the problem.

If you hear bubbling from the toilet, turn on the water in the sink.The main drainpipe is blocked if it bubbles.The problem is only with the tub and toilet if it doesn't.

A vent stuck is a piece of pipe that runs through the roof of the house.It allows waste to easily flow down the drainpipe and into the sewer lines.

sewer gases can't flow out if the vent stack is blocked.When the bathtub is drained water pressure will build up inside the vent and cause sewer gases to escape through the toilet.

The water at the bottom of the toilet bowl is supposed to prevent sewer gases from entering the bathroom.Due to the volume and pressure of the draining bathtub water, the trapped sewer gases pressure will breach the toilet bowl water barrier, resulting in a bubbling/gurgling toilet.

If you have a main drainpipe that is not working, you will not be able to dispose of your waste in the sewer lines.It is in the drainpipe.

When you drain the bathtub, your toilet or other adjacent fixture will be bubbling or gurgling.Things will not be that way for a while.

As more waste accumulates in the drainpipe, it will run out of space and there will be a backup.Sewage can come out of your toilet, sink or any other fixture.

A backup is unlikely if it is a partial clog.Each time the bathtub empties, the toilet will continue to bubble.

If you fix a partial clog, it can become a full one in no time.It will be easier to fix.

It will cost you a lot of money if the toilet is backing up.You will need a professional to fix it since you are less likely to do it yourself.Those are not cheap.

There is an awful odor that comes with a house that has a backing up problem.You might not stay in the house until the problem is fixed.

There are several ways to fix a toilet.The solution can be either easy or expensive.It will depend on:

Chances are high that you own a bathtub plunger.Here is the best way to clear a bathtub.

Allow the water to drain.If the bubbling from the toilet has stopped, listen carefully.You will need to upgrade to a better tool if it hasn't already.

You shouldn't use chemical-based drain cleaners to clear a bathtub.It is better to use hot water and baking soda.

A bathtub snake has a handle and a cable.It works on the drainpipe.You can either buy or rent a snake.

As you crank the handle clockwise, introduce the snake slowly inside the tub drain.When you see an obstruction, change the cranking direction then crank again in the original direction until you get to it.

Pull the snake out if you can't go past a certain point.You might have pulled out the clog if you hooked it.Due to its design, bathtub clogs are not as nasty as those found in toilets and a snake will easily shred/ pull them.

It's important for people with the most powerful toilets to have a toilet plunger.It's helpful in removing obstructions that aren't too far down the drainpipe.

There are different types of toilet plungers.The toilet bowl outlet is not a flat surface, so other plungers won't work.The bell-shaped toilets are the best.

You can make an air-tight seal around the bowl outlet with the bell-shaped toilet plunger.If you want to learn how to fix plumbing problems, this post is for you.

A toilet snake is about 3 to 6 inches in length.It acts like a bathtub snake by shredding it into small pieces or hooking it and pulling it out.

Tub snakes are not as reliable as toilet augers in removing stubborn clogs, especially those further below inside the drainpipe.

You can rent or buy a longer motorized toilet.Home Depot is a home improvement store.

The main challenge in using a toilet auger is that you can easily and badly scratch the inside of your toilet bowl leaving it with very ugly marks.If you would like to learn how to fix a malfunctioning toilet, this post is for you.

You should make sure that your vent stack is free of obstructions.The vent stack can be blocked by tree leaves if it is open at the top.

If you want to check the condition of the vent, you can use a ladder.See if you can pull something out with your hands or a wire.

Next, use a garden hose to pour water down the vent stack.The weight of the water inside the vent will cause it to be washed down the drain.

When you can't get anything to work, it's time to call in a professional.The guys have seen a lot of plumbing problems and will know what to do.