Never use a chainsaw to cut above your head. Before you refuel, allow the chainsaw to cool down. When moving from tree to tree either turn off your chainsaw or engage the chain brake.Dec 29, 2019
Is it safe to cut with the tip of a chainsaw?
Cutting from the underside of a branch requires you to cut with the top of the bar. This is a little unnerving at first because the saw pushes toward you. But it's safe as long as you're well braced and follow all other precautions.
What should you not do with a chainsaw?
Don't Cut With Improper Blade Tension A overly loose or tight chain also wears out the drive sprocket and causes rapid chain and bar wear. To determine if your chain is properly tensioned, pull up on the chain. The drive links should still be in the bar groove. If the links come out of the bar, the chain is too loose.Dec 3, 2018
How do you use a chainsaw for the first time?
If you're starting the saw between your legs, place the back handle between your thighs and hold the front handle firmly with your left hand. Pull the starter handle with your right hand until the engine fires. Push the choke and pull until the saw starts. Release the chain brake.
How do you operate a chainsaw?
https://www.youtube.com/watch?v=9NP-1iiy8P4
Can you ruin a chainsaw chain?
It's pretty hard to ruin a saw chain as re-sharpening is part of normal upkeep. Sticking it in the dirt, rocks, and nails won't do the chain any good but sharpening will restore the cutting edge. The only thing that comes to mind as to the quickest way to ruin a chain would be to run it dry.
What safety precautions are needed when using a chainsaw?
Proper personal protective equipment must be worn when operating the saw, which includes hand, foot, leg, eye, face, hearing and head protection. Do not wear loose-fitting clothing. Be careful that the trunk or tree limbs will not bind against the saw. Watch for branches under tension; they may spring out when cut.
Is it bad to cut ice with a chainsaw?
Yes, you can cut ice with your chainsaw. You don't have to apply any mineral oil to prevent the water from pollution. To prevent the blade from rusting, you will have to look after your chainsaw.
How do I stop my chainsaw kick back?
- Read the manual.
- Make sure the chain brake works before you start.
- Use low-kickback chains.
- Use a sharp chain.
- Be wary when felling tree trunks.
- Pay attention to the nose of your chainsaw bar.
Why does my chainsaw bounce when cutting?
Too much slack in your chain can cause the saw blades to jump the bar. This is commonly referred to as throwing the chain. Even if your chain saw is not throwing its chain, the tension might not be correct. ... Place a dime between the chain and bar, then increase the tension until the chain is snug against the dime.