I have a Whirlpool Cabrio dryer with an F30 code.

The Cabrio Dryer takes too long to dry clothes.There is excessive lint inside the dryer drum and the clothes are taking too long to dry.The Cabrio Dryer does not have proper air flow.

Why does my dryer say af?If there is a restricted air flow condition, the letters "AF" flash, meaning that 3 consecutive cycles were run with less air.Check the entire system for any problems.Look for the door seal and drum seals.

Touch the display pad to clear the error code, or press "Pause/Cancel" if applicable.Press "Start" if you want to start a new cycle.If the problem persists, turn off the Cabrio.It's best to wait several minutes before restoring power.If the unit won't reset, contact Whirlpool.

To clean inside the dryer, turn off the gas, then open either the top or the front.The same procedure is used for both gas and electric dryers.Pull out the two screws on the side of the lint filter opening for dryers with a solid front panel.

There could be an issue with the water flowing into the machine if "LF" is displayed.To make sure the water inlet hoses are free of obstructions, check them.Shutting off the water supply and removing the inlet hoses from the washer is what this means.

The control board is having difficulty communicating with the motor when the Whirlpool Cabrio displays an F1 error.If you want to fix your F1 error, you need to plug your washing machine back in for 15 minutes.You will need to replace the control board if this doesn't work.

The main control of the whirlpool Cabrio dryer has a power failure because of a loss of voltage from the power supply or the board.A power surge can cause the error.

F3 is an open oven temperature sensor.F4 is a shorted oven temperature sensor.The control board needs to be replaced.The function key is stuck and the control board needs to be replaced.

The whirlpool duet dryer e3 error is caused by either the logic chip in the main control failing or the user interface being replaced with the wrong part.

If the drying times are too long, you should clean the lint screen.The amount of hot air reaching your clothes can be reduced by a dirty lint screen.The vent may be blocked with lint if you don't feel air movement.

The cabrio was 4.8 Cu.The washer has a large capacity for washing more laundry in a single load and features a Color Last option to help keep colors vibrant.It's easier to choose the right level of care with intuitive controls.

There is a reset button on the control panel.The dryer should be cool for about ten minutes if the motor isn't running.The reset button needs to be pushed.The dryer should restart if there are no problems with the motor, switches, or electrical system.

The dryer will need to be reset if it displays an error code indicating a power failure.To restart the dryer, you have to press "Start" for a few seconds.Press "Start" to begin if the dryer does not restart automatically.

There is a miscommunication between the control board and the rest of the machine that causes the Whirlpool Cabrio dryer F1 error.

The washer and lid need to be cleaned.The control panel can be reset if the washer is unplugged.If the problem doesn't go away, plug the washer back in.Press/ hold for 3 seconds.Release for a few seconds.Hold for 3 seconds.Release for a few seconds.Hold for 3 seconds.Release.

The dryer's drying time is dependent on the flow of air through the machine and the condition of the vent hose.The rate at which clothes are drying in your dryer could be reduced if air is impeded in its pathway out of the dryer.