How to set up Mazda Homelink, Mazda of South Charlotte, and more.

You know what I can't get enough of?There are remote controls.No one ever said that!You will be able to do without this remote control if you watch the video.In this video, I will show you how to link any additional remote control devices you have in your Mazda vehicle for opening garage doors, security gates, or turning on lights.

The home link controls can be found on the driver's side visor, overhead console or the rearview mirror.Let's start.

The engine should be turned off.Don't let me stop you unless you have something better to do.I don't have anything else to do.

Are you still here?That is a relief.Pets are not allowed to use your garage door as their favorite spot.I had to change my parrot's name.Press and hold the two outer home link buttons until the red light comes on.This clears the home link's memory so it can be used for programming.It is time to show the remote who is in control.You can point the remote control device at the home link system.If you want to use the home link button on the remote device, you need to press the activation button at the same time.The red light will change from flashing slowly to flashing rapidly if you hold the buttons down.It could take up to 90 seconds.You will know you have successfully programmed your home link when the light flashes rapidly.All you have to do is press and hold the button when the device is activated.Thank you for your technological mastery.Very impressive.If you want to connect other devices, repeat steps two through four.Put that remote with the shoe trees, the extra screws that came with those shelves, and everything else you will never need because you are done.Click on FAQ for more information.How to Set Up Your Mazda Homelink is a post by Bookmarkify.

Are you still here?That is a relief.Pets are not allowed to use your garage door as their favorite spot.I had to change my parrot's name.

Press and hold the two outer home link buttons until the red light comes on.This clears the home link's memory so it can be used for programming.

It is time to show the remote who is in control.You can point the remote control device at the home link system.If you want to use the home link button on the remote device, you need to press the activation button at the same time.

The red light will change from flashing slowly to flashing rapidly if you hold the buttons down.It could take up to 90 seconds.You will know you have successfully programmed your home link when the light flashes rapidly.

All you have to do is press and hold the button when the device is activated.Thank you for your technological mastery.Very impressive.