How to Patch a Hole in the Wall is an easy way to fix a hole in a wall.

When wall anchors or screws are used to attach cabinets or wall hangings, there are actual holes in the wall that are called drywall screw depressions.The screws should sink just below the paper's surface during installation.The wall needs to be filled before it can be painted.When wall anchors or screws are used to anchor cabinets, shelves, or pictures to walls, you are left with holes that penetrate through the drywall panels.

Before covering the holes with joint compound, the face paper on the puckers needs to be trimmed.You need a hole that is not straight in order to smoothly cover these areas.This usually occurs when screws or wall anchors are removed from the wall, but it can also happen when drywall screws are driven too far during installation, breaking the paper and causing it to pucker outward.

The face paper can be forced inward by pressing them with the handle of a screwdriver.If this doesn't work, you can use a utility knife to cut through the paper around the pucker, then peel away the gypsum to make a hole in the wall.If there are any puckers left, you should brush your hand over the area.

Buttering is when you dip the end of a knife into the joint compound.The front edge of your knife should have a small amount of compound on it.overloading the knife will lead to a mess.

If necessary, use a shop towel or paper towel to wipe off excess mud, especially from the side edges of the drywall knife.It's not necessary to get the back and sides of the knife completely clean, just remove any hanging mud that might drop off.

A small container of premixed joint compound is more convenient for this kind of repair.

An ordinary putty knife can be used to apply joint compound on small screw holes.

Press the front edge of the knife against the wall to draw it across the hole.As you draw the knife, the blade should bend slightly.

Make sure the hole is filled with joint compound.If you see any marks, fill them with a follow-up pass of the knife.Don't worry about getting the surface flat.

Immediately make a second stroke across the hole with the drywall knife, this one at 90 degrees to your first stroke.The purpose of this stroke is to flatten out the compound so it is flush with the wall.To remove excess mud, use the edge of your knife.This can pull joint compound from the hole if you make repeated passes of the knife.