How to install a Dimmer for a floor lamp or a table lamp.
Do it together home improvement and remodeling is what BuildingMoxie.com is about.There are a lot of tips and tricks about the home.
With the summer heat closing in on us, your lawn and landscape may need some extra care to stay healthy and thrive throughout the season.You will need to keep your outdoor investments looking good all summer long if you don't have an irrigation system.
There are two large parts, each containing a few small steps.You need to secure your plaster and finish your repair first.I get the wall ready for paint by reviewing Big Wally's Plaster Magic.
That doesn't mean that every screw is the same.If you want to mount deck boards to a deck frame with drywall screws, you are not going to do it.You wouldn't use upholstery nails or thumbtacks to hold down your roofing shingles.The screws I presented at the top were not designed to do those kinds of things.Click to read more.
Not every table lamp has an in-line cord-operated dimmer, but you can attach a foot-control dimmer to a floor lamp to adjust the light level for different times of day.
Dimmers help save money on utility bills.They are easy to install.The lamp-base dimmers can be put directly into the lamp's sockets.Plug-in foot-control floor lamp dimmers allow you to simply plug your lamp into the dimming device.A few basic tools are required to install in-line cord-control dimmers.There is a way to install a dimmer.
A basic homeowners toolkit contains most of the tools needed for this job.The ten essential tools for home owners can be found in our article.
Plug your lamp back in.You can add the dimmer switch to the lamp by selecting the position along the cord.Pick a spot that is easy to reach, such as a chair or bed.
If you want to add a dimmer switch to your lamp, you need to separate the two wires of the lamp's cord.The neutral and hot strands of the cord have the same insulation.To install your dimmer, slice through the hot wire at the center of the juncture.Use the wire strippers to remove insulation from both ends of the hot wire.
Remove the cover of the dimmer switch.The manufacturer's instructions say to place the neutral wire along the inside of the switch box.Place the cut ends of the hot wire under the two terminal clamps with the help of long-nose pliers and turn the screws with a screwdriver.Attach the dimmer switch cover to the switch.
The dimmer switch needs to be plugged in and turned on to make sure it works.The dimmer should be adjusted as desired.
Jean Nayar is a journalist, the author of eight books on decorating and design, and the founder of TheHappyHomeWorkshop.com.
There are categories for lighting and electrical on BuildingMoxie.There is lighting.There is electrical here.