You can use it for a long time with a rechargeable battery.You have to charge the battery with the device'susb charging port over time.If you lose your phone's charging port, you can cut a few wires from the phone cord to make your own.Your device will be fully charged in about an hour.
Step 1: The port has ausb charging port.
The charger that comes with your device has a plug that can be used in multiple locations.You can use a portable battery, laptop, or a wall charger.If you want your device to not fall off of it while it is charging, make sure the charger is on a flat surface.You can use any device that has ausb drive.
Step 2: The bottom of the device should be plugged in.
Make sure that the side of the device that has 4 slots is facing down.Place the JUUL device upright on top of the charger.The light on the front of the device is going to start flashing.Make sure the JUUL device is not charging in an area where it can be easily knocked over.Try a different plug and make sure power is connected if the light doesn't start flashing after the device is plugged in.
Step 3: Double-tapping it will show the charging status of your device.
You can see how close your device is to full by touching the light on the front twice with your finger.The device has a low charge when the light is red.If it is yellow, the device has a medium charge and a high charge.The charge from an empty to a full battery takes about an hour.
Step 4: The phone cord has a smaller end.
Make sure the phone charging cord is unplugged.Take a pair of scissors and cut off the phone cord.Throw the cut end away when you are done.You could get shocked if you cut the wires while they're plugged in.
Step 5: There are wires inside the phone cord.
Remove the wires from the phone cord to separate the cords.Remove the plastic coating from one of the wires by placing the edge of your scissors against it.Remove 4–2 inch from the end of the wires.You don't need to remove the wires.Black wires will be in a silver case.
Step 6: The wires should be put into the left and right ports.
The light will be facing up if you place your device on a flat surface.The phone cord is at the bottom of the device.The left and rightmost slots on the device have red and white wires in them.It has a solid connection if you push them in as far as possible.The wires might fall out if you position your device differently.The red and black wires could cause a spark when plugged in.
Step 7: The cord needs to be plugged into a wall charger.
The other end of the phone cord can be plugged into a portable battery.Don't use a laptop or other electronic device, it could cause a short circuit and damage your device.If you need to adjust wires, make sure your power source is nearby.Live, exposed wires could potentially start a fire if you don't leave your new JUUL charger plugged in when you're not using it.
Step 8: Put the wires in place.
Reposition the wires until you can see the light on the device.Wrap electrical tape around the base of your device when the light blinks.Leave your device to charge for an hour.Plug the cord into another device if the lights don't work.Since you had to expose wires, never leave the device unattended.