Kilims are pileless rugs that use flat-weaving techniques for a colorful design.Special treatment is needed to avoid damaging the fibers of the floor covering.A kilim rug needs to be cleaned by hand with a brush and vacuumed to avoid tearing it.Stubborn marks should only be treated by professional cleaners.
Step 1: To remove debris, sweep both sides of the rug.
You want to make sure that there is no dirt or dust on the rug.If you want to brush the other side of the rug, you have to run a broom over the entire surface.The cleaning process should be easier if the carpet is on a flat surface.The most effective way to clean a rug is with a hand broom, which is a handheld brush with long bristles.
Step 2: It is a good idea to mix the carpet wash with warm water.
To create a gentle cleaning solution for the kilim rug, combine 12 cup of carpet wash designed for hand cleaning rugs, 4 cups of warm water, and a small amount of white vinegar.Make sure the ingredients are well blended.The colors in the rug will not run if the vinegar is used.
Step 3: Apply the solution gently with the brush.
Use a scrub brush with strong bristles that are wet but not dripping.The brush should be stroked over the rug by starting in one corner and brushing up and down.Continue brushing until you have cleaned the entire rug.The brush should not be used to scrub the rug.You may damage the rug if you are too rough.Work the brush over them vertically when you reach the fringe.It's not necessary to go over them again.When the brush seems to be getting dry, re-wet it.
Step 4: Go over the rug a second time.
Rub the brush over the left side of the rug after you have brushed it.Continue brushing until you have cleaned the entire rug.
Step 5: On the other side of the rug, repeat the process.
Turn the rug over to the other side if you brushed it in both directions.The second side of the rug needs to be cleaned the same way as the first side.You may want to repeat the cleaning process on both sides if the rug is dirty.
Step 6: The rug needs to be washed with clean water.
Run your bristle brush under water to remove the cleaning solution and dirt.If there is no cleaning solution left behind, wet the brush with warm water and brush over the rug vertically and then rinse it.It is possible to rinse the rug more than once with a wet brush to make sure there is no leftover mess.Don't let the rug get fully soaked if you use a hose to rinse it.
Step 7: To dry the rug, leave it flat.
If you can, lay it on an inclined surface.You can either leave it under a fan or set it out in the sun.It may take up to two days for the rug to dry.It's a good idea to flip the rug every six hours to make sure it dries on both sides.Don't put anything on the rug until it's completely dry.When the rug is dry, use a dry brush to remove any leftover cleaning solution.If you leave the rug outside, put it on grass or gravel.
Step 8: The rug needs to be vacuumed weekly.
If you keep your kilim rug free of dirt and dust, you won't have to scrub it often.It's usually enough to run a vacuum over it once a week, but you may want to do more if the rug is in a busy area.
Step 9: Use a low-suction device.
It is possible to keep your kilim rug clean with a vacuum cleaner, but you should not use a high vacuum setting or a revolving brush.Both can cause damage.The extension hose or crevice tool attachment can be used if your vacuum doesn't have a low-suction setting.If you have a handheld vacuum, use it.They aren't powerful enough to damage the fibers.
Step 10: The rug needs to be vacuumed both sides.
The kilim rug doesn't have the backing of other rugs because it is hand-knotted.To keep it clean, make sure to run the vacuum over both sides.
Step 11: The fringe is a good place to avoid vacuuming.
The fringe adds to the charm of a kilim rug.If you run your vacuum over the fringe, it may grab the fibers and tear them off.
Step 12: Solids should be removed from the spill.
If there are any solid pieces in the food or item you spilled, use a spoon to scoop them up.If you use too much pressure to remove them, you may end up pressing the items into the fibers and making the stain worse.
Step 13: As much of the liquid as possible be thrown away.
Carefully press against the stain with a clean sponge or piece of paper towel.If you want to avoid spreading the stain, start blotting at the outer edge of the spill.Lift the rug and clean the floor after the spill.
Step 14: Put a container under the stain by lifting the rug.
You need a container to catch the water because you will be rinsing the rug.A shallow Tupperware container works well.
Step 15: Clean water can be passed through the stained area.
Clean, warm water is what you'll get when you fill a small glass, mug, or bowl.If you pour it over the area, it will wash the rug and go into the container below.The amount of water you need depends on the size of the spill.Add more if necessary to fully rinse the area after starting with 12 cup.
Step 16: Remove the rug.
Remove the container after you rinse the rug.Place the rug on the ground again and use a clean sponge or piece of paper towel to clean up the mess.A professional rug cleaner can handle the job if there is a stain left behind after rinsing and blotting the stain.The rug may be damaged if you try to remove it yourself.
Step 17: Baking soda should be used to cover the urine-stained area.
If the urine has already dried, it can be difficult to remove.If the rug is still damp, sprinkle a thin layer of baking soda over it.A professional rug cleaner can clean dried pet stains.
Step 18: Put a clean cloth over the stain.
It's a good idea to use a white towel or rag on the rug.Once the cloth is in place, apply heavy pressure to the area for 2 to 3 minutes to drive the urine into the baking soda.Pressing on it can be done by stepping on the cloth.
Step 19: The process can be repeated if the baking soda is removed.
Remove the baking soda from the rug with a spatula.If the rug is wet, repeat the process.
Step 20: There is a container beneath the stained area.
Lift the rug up and put a container such as a baking pan or Tupperware container under the affected spot.Put the rug over the container.
Step 21: Let the stained area dry by rinsing it with water.
You can fill a glass or mug with warm water and white vinegar.It's a good idea to wash the affected spot on the rug with it.You can discard the water if the container beneath catches it.The rug should be dry for 12 to 24 hours.The urine removal products may damage the fibers.