Most foam lances require a minimum of ~2 gallons per minute (GPM), but the more basic (and affordable) electric pressure washers are generally around 1.2-1.6 GPM, well below the 2 GPM minimum.18 Aug 2017
Does foam cannon work with 1.2 gpm?
It works with pressure washers with 1.2GPM and over 1,000 PSI. This cannon is easy to operate, doesn't use a lot of soap, and shoots out an amazing stream of soap.21 Oct 2021
How do you connect a Karcher to a foam cannon?
https://www.youtube.com/watch?v=ckztGhjSDqg
What is foam cannon orifice?
The role of the orifice in simple terms is to control the amount of water/flow that comes through the foam cannon. They come in a variety of sizes and the size you need is a component of the flow rate (gallons per minute gpm) and pressure (pounds per square inch psi) of your pressure washer.10 Apr 2020
What size orifice does the trinova foam cannon come with?
This one comes shipped with a 1.2 orifice, if your running an electric pressure washer you may want to swap it out for a 1.1 if you have low gpm.
How do you install a foam cannon orifice?
https://www.youtube.com/watch?v=nSMSq8TTmE0
How do you replace a foam cannon orifice?
https://www.youtube.com/watch?v=i4fHag8W4q4
What is the purpose of a foam cannon?
A foam cannon is a piece of car washing equipment that mixes the perfect amount of car wash soap, water, and air to generate thick suds, then shoot them all over your car using the power of a pressure washer.
How many PSI do you need for a foam cannon?
Check the GPM(gallons per minute) value on your pressure washer. Electric pressure washers can also be used, but we would recommend that it at least have a GPM of 1.75 and a 1900 PSI rating.28 Dec 2017
How do you get the best results with a foam cannon?
https://www.youtube.com/watch?v=LEEkwhm0muI
Is 1.1 gpm good for foam cannon?
The role of the orifice in simple terms is to control the amount of water/flow that comes through the foam cannon. If you are using a pressure washer operating between 1.3 1.8 gpm and under 2000 psi a 1.1mm orifice is likely a good starting point.10 Apr 2020
Can you use a foam cannon with any pressure washer?
The foam cannon will still work if you are using a less powerful pressure washer. Some Ryobi, or Greenworks' models which are rated for around 1.2 GPM and 1600 Psi. However, you should expect the foam to be more runny. We recommend that you start with whatever pressure washer you have.28 Dec 2017