How do you connect a TrolMaster to a dehumidifier?
Peel off the outer sheath of all signal cable of a dehumidifier to reveal the copper wire. Then, insert each bare wire into the corresponding terminals on the back panel while pressing the button of the terminal designation at the same time. Release the button to clamp the wire in each terminal.
How do I update TrolMaster firmware?
https://www.youtube.com/watch?v=HkGyzY6o4r8
How do you hook up a TrolMaster?
Connect the cable going from the DEVICES connector to the first Device Station to be connected. Use the T-shape splitter and short RJ cable so that the first cable can continue on to be connected to the next T-shape splitter (Device Station) to be connected. Plug the Device Station to the wall outlet for power supply.
How do you connect CO2 to TrolMaster?
Connect the CO2 sensor to the controller. Plug the Controller into a 120V NEMA 5-15 wall outlet. Program the desired settings before connecting to CO2 generator or regulator. Plug the CO2 device into the power outlet of the unit.
How do I update my TrolMaster on HS 1?
Press and hold “Addressing” button while replugging the RJ12 cable, the upgrade process will be done automatically.
How do you update TrolMaster?
Go to Settings – Import / Export, select Import / Export all settings. In the bottom window, select a file name for the settings to be saved as. Save the file on the USB drive. Select the USB drive to update the firmware.Nov 20, 2020
How do you calibrate a TrolMaster humidity sensor?
- On the HCS-1 go to System – Calibration. / ...
- Next select the item you want to calibrate.
- Using your observed reference temperature or humidity reading, change the calibration on the TrolMaster controller to read the same readings. ...
- The sensor is now calibrated to your new reference point.
How do I connect Anden to my TrolMaster?
- Plug unit in and turn power switch to ON.
- The on-board control screen should display OFF. ...
- Hold the MODE button on the on-board control for 3-5 seconds to enter the installer Set-up Menu. ...
- Press the UP or DOWN button to change to ENABLED.