How do you use autoblock?

How do you use autoblock?

- Buy or make an friction hitch / autobloc cord. - Attach the autobloc cord to the leg loop of your harness. - Wrap the autobloc cord around the brake side of your rappel rope. - Hold the autobloc back while you rappel. - Release the autobloc hitch for a hands-free break in your rappel descent.

What is autoblock length?

Use Cord for Your Autoblock Use a thin cord (best if it's 5mm or 6mm in diameter). You'll need a 48-inch length of cord to make this loop. The finished length should be 18 inches long after the ends are tied together with a double fisherman's knot forming a closed loop.26 Oct 2017

How do I make an autoblock?

https://www.youtube.com/watch?v=KHMSF6Py8Yc

Where do you put autoblock?

https://www.youtube.com/watch?v=P5DZeEV77Z4

What is an autoblock in climbing?

An autoblock (or autobloc or "third hand") is a rope device used in climbing and caving for both rappelling (downward) and ascending (upward). It is made using a friction hitch around the rope, connected by a carabiner to the climber's harness, and may be combined with other climbing equipment for further safety.

How do you rappel?

https://www.youtube.com/watch?v=7U6tdEevJgs

How do you rig a rappelling device?

https://www.youtube.com/watch?v=Nt7WsuPLTeY

How long should an autoblock be?

18 inches long

What length should a prusik be?

The prusik uses 5 mm or 6 mm accessory cord that is joined at the two ends with a double, or triple, fisherman knot. The most common length of cord is about 1.5 metres for a short prusik and 1.83 metres for a long.7 Feb 2017