- Place the GPS receiver in a location on the jobsite where equal range in all directions provides full coverage of the site. ...
- Place the GPS antenna in a location that has a clear line of sight to the sky in all directions. ...
- Place the GPS and radio antennas as high as practical.
How do I setup my Trimble GPS base station?
https://www.youtube.com/watch?v=0NUNNdR_6GI
How do I set up Trimble?
- Set the antenna over the ground mark using a tripod, a tribrach, and a tribrach adaptor.
- Use the tripod clip to hang the receiver on the tripod. Alternatively, place the receiver in its base case. ...
- Assemble and erect the radio antenna.
How do you set a base and rover?
https://www.youtube.com/watch?v=LzpnOEjO6T8
How do you set up a Trimble?
https://www.youtube.com/watch?v=6KRKD8fFdLY
How do I connect my Trimble GPS?
- Step 1: Start Trimble Access.
- Step 2: Click on settings.
- Step 3: Click on Connect.
- Step 4: Click on GNSS contacts.
- Step 5: Add New GNSS contacts.
- Step 6: Add Name and Network.
- Step 7: Enter FPRN and Wi-Fi.
- Step 8: Setup NTRIP Configuration.
How do I set up RTK GPS?
- Start QGroundControl and attach the base RTK GPS via USB to the ground station. ...
- Start the vehicle and make sure it is connected to QGroundControl. ...
- QGroundControl then starts the RTK setup process (known as "Survey-In"). ...
- Once Survey-in completes:
How do you set up a base station?
- Connect the power cord to the Power port on your base station, then plug the power cord into a wall outlet.
- Connect an Ethernet cable to the WAN port on your base station, then plug it into your DSL or cable modem.
How do I reset my Trimble base station?
- In either case, the receiver will be set to DHCP. ...
- No GPS data will be lost.
- All settings will be reset to factory defaults.
How do you use Trimble RTK?
- Select Jobs to start and new job or open existing one. ...
- Select Measure: RTK , then Start base receiver.
- Your TSC3 will connect to the Base receiver via Bluetooth. ...
- Point name: Select from List or Key in the coordinates of your position. ...
- Antenna height. ...
- Press Start. ...
- Select RTK.
Why do you want to use a fixed pole versus a tripod for your basestation?
The fixed height tripod is quicker and easier to set up over a control point. It allows you to re-establish the antenna height exactly so that the receiver can be set up faster without using the SCS900 software or without needing to enter a revised antenna height in the receiver front panel.
What is a base station in construction?
The base station is typically installed at a fixed or semi-permanent location, such as the roof of the site office. It consists of a GPS receiver, GPS antenna, radioantenna, radioThe origin of the word antenna relative to wireless apparatus is attributed to Italian radio pioneer Guglielmo Marconi. In the summer of 1895, Marconi began testing his wireless system outdoors on his father's estate near Bologna and soon began to experiment with long wire "aerials" suspended from a pole.https://en.wikipedia.org › wiki › Antenna_(radio)Antenna (radio) - Wikipedia and radio antenna.Feb 3, 2016