How do you use a lock washer and flat washer together?
How do you use a lock washer and flat washer together?
Method 1 of 3: When used correctly, a lock washer will hold the nut or other threaded fastener in place. To help it accomplish this, put the lock washer on first, below the fastener. If your project calls for other washers or hardware elements, they should go on before the lock washer so that it can hold them in place.
Should you use a lock washer with a flat washer?
In general, I use a flat washer under a split locking washer to protect the base material, plating, or coating from damage caused by the split washer action. I may also use the flat washer to distribute the fastener load or ensure the split washer does not fall or grind into a larger clearance hole feature.2007-08-07
Which end does a lock washer go on?
The washer helps prevent damage to the surface of the object being fastened. In most cases where the bolt is easier to turn, the bolt has a round head that will cause less damage anyway. For the same reason, lock washers always go on the nut side to stop the nut moving.
What is the difference between a lock washer and a flat washer?
Flat and lock washers are two of the most common types of washers. A flat washer is a basic washer that's flat on both sides. A lock washer is a semi-coiled washer that's used to secure bolts in place.2020-10-20
Which way does a lock washer go on?
The washer helps prevent damage to the surface of the object being fastened. In most cases where the bolt is easier to turn, the bolt has a round head that will cause less damage anyway. For the same reason, lock washers always go on the nut side to stop the nut moving.
How do you use a washer and spring washer?
Spring washers should be used on the nut side of the fastener. If an additional washer is required to spread the load (as in our image above) it should be used between the spring washer and the mounting surface, i.e. the spring washer should be positioned next to the nut.
Does it matter which way washers go?
There is no fixed rule about which side goes up and which goes down, but given the issue of bearing surface pressure mentioned above, it's more effective to put the burred side facing down.2016-12-21
What order do bolts and washers go?
If there is only one washer used with a nut/bolt, it usually goes on the nut side. The nut in most circumstances is more movable, and is more commonly turned to tighten the assembly. The washer helps prevent damage to the surface of the object being fastened.