How do you run a diagnostic on a Whirlpool washer?

How do you run a diagnostic on a Whirlpool washer?

https://www.youtube.com/watch?v=Q239fB24wxY

Is there a reset button on a whirlpool?

Rotate your dial until you have the following three lights illuminated: RINSE, WASH, and STOP. Then turn off your washer and unplug it for ten seconds. When you turn it back on it should be reset.

Why won't my Whirlpool washer drain and spin?

If your Whirlpool washer Not Spinning well, you need to check the pump. It could be clogged with debris or defective and needs to be replaced. To check the pump, disconnect the drain line and remove the back panel of your machine. Check for debris with a flashlight, or check with a special tool.

How do I know if my Whirlpool shift actuator is bad?

When the actuator fails there is usually and awful lot of grinding noise, and the tub and agitator operate at a slow speed, if at all. In most models, you will have an F7 -E1 or E5 error code in the display.Feb 22, 2013

How do I run a diagnostic on my Whirlpool washer?

https://www.youtube.com/watch?v=Q239fB24wxY

How do I reset the control panel on my Whirlpool washer?

Rotate your dial until you have the following three lights illuminated: RINSE, WASH, and STOP. Then turn off your washer and unplug it for ten seconds. When you turn it back on it should be reset.

What would cause a Whirlpool washer not to start?

One reason your appliance may not start is that it has simply come unplugged or that the outlet that it is plugged into has tripped your home's main circuit breaker. If you notice a tripped breaker, leave the breaker off and carefully inspect the electrical outlet and power cord for any sign of a problem.Feb 23, 2021

Does a Whirlpool washer have a reset button?

Method 1: Unplug it The first way you can reset whirlpool washer top load is by unplugging it for about 2 minutes then plug it back in and wait about 30 seconds before starting the washer again. This performs a hard reset on the machine and it will start over after you reconnect it again.