Why is my PUR water filter still flashing red after filter change?
It's supposed to flash red when it's time to change filters. I believe it's based on time, not volume of water but I could be mistaken. It can be reset by removing the filter, leaving it off at least 30 seconds and replacing it. ... The filter should be replaced about every 4 months, depending on how much it is used.
Does PUR water filter have a battery?
Batteries keep your electric PUR filter running properly. ... The battery chamber for PUR's electronic filter is located underneath the sink, so check it occasionally. The system comes with an indicator light that lets you know when to replace its batteries.
Why is my new PUR filter not working?
PUR filters may be slow because of air blockages, high sediment levels, hot water or mineral damage, incorrect installation or an old filter. The PUR MineralClear® filter may also result in longer filtration times than the basic filter because of greater contaminant reduction.
Why is my water filter still red?
These lights typically correspond with how the filter is doing. Most of the time, you can get a full six months of use with one filter without any problems. Just because your light turns red doesn't mean your water is not being filtered. It merely means you should change your filter soon.2 mar 2016
How do you reset a PUR pitcher?
To reset, hold the reset button in for 3 seconds until all 3 lights flash, then release. Make sure when you are holding the reset button in it doesn't become stuck. If it does, gently pull up on the button and it should spring back into place.