Slip one pipe wrench onto the fitting and the second one on the cleanout plug. Then give it all you've got. If the plug breaks loose, you're home free. Start cleanout plug removal by applying gentle heat to the cleanout plug and fitting to soften the old pipe dope (Photo 1).
How do you change a sewer cap?
https://www.youtube.com/watch?v=Za2QJS2kjFs
How do you remove a PVC drain cap?
- Turn off the water to the capped-off pipe. ...
- Look for a faucet connected to the water line and open it. ...
- Align a hacksaw with the edge of the cap and place it on the pipe as close to the cap as possible. ...
- Remove the cap and let the water drain.
How do I remove a stuck PVC sewer cap?
Put a good wrench on it, one that doesn't have a lot of play in it. Put a pipe on the handle of the wrench — 2 ft should be long enough. Gently tap the end of the pipe with a (preferably 'dead blow') hammer. Eventually, it should come loose.
How do you remove a pipe plug?
If a square head plug is to be removed, pound on the head of the plug using a one pound hammer. Rhythmic blows, not too hard, should be used and continued for a minute or more. A spray penetrant, like WD-40, always helps. Use a large wrench, like a 12″ crescent to remove the plug.
How do you remove plastic cleanout caps?
Use an adjustable wrench or adjustable pliers to unscrew the clean-out plug from a P-trapP-trapIn plumbing, a trap is a U-shaped portion of pipe designed to trap liquid or gas to prevent unwanted flow; most notably sewer gases from entering buildings while allowing waste materials to pass through. ... In domestic applications, traps are typically U, S, Q, or J-shaped pipe located below or within a plumbing fixture.https://en.wikipedia.org › wiki › Trap_(plumbing)Trap (plumbing) - Wikipedia. Place a bucket under the trap to catch the water that will spill out when you remove the plug. Turn the plug counterclockwise to remove it, install the replacement, and turn it clockwise to tighten it.