How do you attach a ledger board to a brick house?
How do you attach a ledger board to a brick house?
- Mark anchor locations on your ledger and drill through the board with a ½” bit.
- Position the ledger against the wall and mark the anchor positions through the hole onto the wall.
- Drill through the brick veneer with a ½ inch masonry bit in a hammer drill, until you reach the wood frame behind.
Can you attach a deck ledger board to brick?
You should never attach a deck to a brick wall. The brick veneer must have a minimum of a 1-inch air space between the brick and the framing, but it can be up to 4.5". ... A lag screw or bolt extending to the front of the brick simply cannot support deck loads at that location.
Can you attach Ledger to brick?
To attach a ledger against a wall through brick veneer: ... Drill through the brick veneer with a ½ inch masonry bit in a hammer drill, until you reach the wood frame behind. Do not drill into the wood. Reposition the ledger board and fit a ½” lag bolt, 10” long into each hole and drive them in slightly with a hammer.Mar 29, 2012
How do you attach a ledger to a masonry wall?
Use a wood bit to drill ½" pilot holes through the ledger board. Next, use a concrete bit to drill into the concrete wall. Install two bolts at the end of each ledger board. Hammer the sleeve anchor through the ledger board into the concrete wall.
Can you use Tapcons for ledger board?
It probably did not equate to us getting many new products but there was a lot of good information regarding fasteners and joist hangers. Titen HD anchors (Tapcons on steroids as some call them) even in galvanized finish are not to be used in exterior application. Never to be used to attach Ledger Boards.Dec 18, 2015
What does the ledger board attached to?
The ledger board must be fastened to the adjoining building's lumber frame. The most common part of the building's frame that a ledger is attached to is the rim joist (also called the “band joist,” “band board” or “rim board”).Sep 7, 2021