- Press the "Sani Rinse," "Heated Dry," "Sani Rinse" and "Heated Dry" buttons on the dishwasher's electronic control panel in quick succession to put the appliance in diagnostic mode.
- Close the dishwasher door and engage the door latch.
How do I reset my Whirlpool dishwasher control board?
Resetting the control board To reset the control board, push the “off” key and remove its power cable. After ten to fifteen minutes, plug in the cord, then turn on the dishwasher and click on “high setting” or “pots and pans” on the control board. Finally, press any “heat” round to dry the dishes on the wash.
Where is the filter on a whirlpool Quiet Partner III?
The filters can be found at the bottom center of your dishwasher.2020-05-04
How do I reset my Whirlpool quiet dishwasher?
- Turn on the hot water at the faucet closest to your dishwasher and wait until the water becomes hot. ...
- Leave the dishwasher door open as you reset it by pressing "heated dry," "normal," "heated dry" and "normal" in quick succession. ...
- Run the dishwasher.
How do I reset my Whirlpool quiet partner 3 dishwasher?
- Press the "Sani Rinse," "Heated Dry," "Sani Rinse" and "Heated Dry" buttons on the dishwasher's electronic control panel in quick succession to put the appliance in diagnostic mode.
- Close the dishwasher door and engage the door latch.
How do I run a diagnostic on my Whirlpool dishwasher?
- 1 – Turn the dishwasher on.
- 2 – Press the rinse cycle button.
- 3 – Turn the dishwasher back off.
- 4 – Hold down the start button while you turn the dishwasher back to on.
- 5 – When the light starts flashing immediately let go of the start button.
Where is the reset button on a Whirlpool dishwasher?
The downside to Whirlpool appliances is that they don't have a reset button. But some of them do have certain error codes. You can identify them from the user manual. If you can't identify the error code, let's start with the most basic step.
How do I reset my Whirlpool quiet partner?
- Turn on the hot water at the faucet closest to your dishwasher and wait until the water becomes hot. ...
- Leave the dishwasher door open as you reset it by pressing "heated dry," "normal," "heated dry" and "normal" in quick succession. ...
- Run the dishwasher.