Can a gun safe be too humid or too dry for weapon storage?

Tarnishing on jewelry pieces can happen, cash and documents can smell, and weaponry can develop rust on them.Photographs can get damaged in a bad way if they can't be repaired.

What is the gun safe humidity level?It is acceptable for a gun safe to have a 50 percent relative humidity.You have to use a hygrometer.

It's possible that condensation inside storage places can make drugs break down faster than usual.It only makes sense that you keep your valuable out of harm's way.

Major temperature changes can occur between night and day when a vault is placed in a non-temperature controlled environment.It can cause damage and condensation.

It is possible for a safe to get wet in a shower or laundry room.You don't need to freak out because it's easy to fix this problem.

There are some dehumidifying products on the market right now that are created using silica gel.

You have seen silica gel before in one form or another.

Every time you buy a new pair of shoes, there is a small packet inside the box.Since you don't know what the purpose of the packet is, you throw it away.

There is a chance that the gel absorbed all the water it could hold, so it no longer serves any purpose.Who would want to store hundreds of these tiny packages in their firearms locker?This is where a gun safe can be used.

The crystals in the canister of these dehumidifiers have a very high rate of absorption to get rid of the atmosphere's humidity.

They can be used inside a safe.The size of the safe will depend on the canister you need, and the good news is that these are renewable.The crystals inside are odorless and non-toxic.The beads will turn pink when they absorb the air's moisture at a higher rate than traditional silica gel dehumidifiers.

It can be seen in the small window monitor on the front part of the canister that shows when you should be drying out the desiccant.

The unit needs to be charged again after the crystals turn pink.It is similar to dipping a sponge into a bucket of water.It means that it can no longer absorb water.

When this happens, you just have to remove the crystals from the safe, pop out the built-in plug on the back or bottom, plug this into the wall outlet throughout the night and the following morning, and it will be brand new again.

If you put this back inside your safe, your worries will be gone.This is a very efficient way of absorbing air humidity.

The models are self-contained in a canister.Not like the rest of the desiccant products, there is no need for you to empty its canister or the small cotton bag, dry it out in the oven at low temperature for a few hours, and try to get all the silica gel crystals back inside the bag or canister without spilling

Another kind of dehumidifier is the electrical rod.These are known by many different names such as heating rod, goldenrod, dry rod and dehumidifier rod.

Dehumidifier rods can produce the same result as a desiccant, but in a different way.Plug it in when you put it inside the safe and it will give you the right amount of heat to warm the air and keep it circulating.

The items in the safe are 3 degrees warmer than the ambient air.The level of humidity in the safe is reduced because of this.

This is an electrical appliance.The safe should be able to hold the plug or cord.The older safes have not been punched or drilled to allow for a plug or cord.The steel might have been used to drill the firewall.If this is the case, you just need to drill a hole through the firewall.Attach the plug to the cord outside and plug it into the wall outlet here.